VX One Mast Up flat top cover, designed and manufactured in the USA.
Our VX One Mast Up Flat Cover is compatible with our VX Hull Cover to completely enclose your boat!
*We currently don't have a picture of this cover on a boat. If you would be willing to take some photos of your new cover from us on your boat we would be happy to give you $10 off your cover order. Thank you for your help!
Features of this cover:
Pop up keel cover with three 1 inch webbing straps with buckles to gather the extra fabric when trailering
4 cutouts one for the Mast, two for the shrouds, and one for the forestay
There is a zipper that goes from the mast cutout, which is closed with a tall 6" collar, to the starboard shroud cutout. The zipper is covered with a flap to protect it from UV damage. There are Velcro flaps that close off from the shroud and forestay cutouts to the edge of the cover, as well as buckles at the bottom edge to connect the 1/4" bungee at the hem.
Cover wraps all the way under the bottom of the transom
Cover extends down the hull of the boat about 6 inches from the gunwale providing a good seal
Optional Mesh Drains / Vents wrap under the back lip of the transom providing air flow and allowing your boat to drain if needed
Well reinforced over all chafe areas (shroud bases, spin blocks, bow, aft corners, pintles, and jib track on foredeck)
Strap under the boat at the transom that runs through webbing loops on the transom flap to keep it secured so it will not blow off (this strap is included on all covers even without the straps upgrade)
Webbing loops can be found about every 3 feet around the cover for you to create your own tie-down system to fit your needs. If you would like the webbing loops replaced with adjustable 1 inch webbing straps with quick release buckles select "Strap" in Upgrades
Bungee in the hem of the cover allows the cover to fit well and seal out dirt and water
The cover doesn't need to be tied down to stay on in moderate conditions with the bungee alone
You can add mesh drains, straps, and/or reflective tape in the upgrade menu found above. We offer this cover in three different fabric types, look over the fabrics in the drop down chart below.
Putting a tennis ball on the top pintle will help extend the life of your cover by distributing the load of your cover at that chafe point! (even if you don't do this we have reinforced this point on your cover with heavy duty truck vinyl so the pintle will not punch through it.
Because we take the time to make sure you are getting what you want and need. Our knowledgeable designers are available by phone or email and can work with you to incorporate any special requests. Our products are warranted against defects due to workmanship or material flaws for 1 year. All our products are made in the USA, on the central coast of California.