Two vents wrap the transom allowing for air flow and allowing the boat to drain
There is a cutout for the keel bulb (the bulb is exposed at the bottom)
There is a zipper connecting the keel cut out to the shroud cutout
The zipper is going to have a flap on the inside of the cover to protect the boat from the zipper and a flap on the outside to protect the zipper from the sun
This cover wraps over the gunwale about 6 inches so there are cutouts for the shrouds as the shrouds are only about an inch from the gunwale edge
Bungee in the hem of the cover allows the cover to fit well and seals out dirt and water
This bottom cover has six one inch wide straps with side release buckles for easy fastening
The bungee is connected at the shroud cutouts with a side release buckle
The transom is fully enclosed
There is a heavy duty truck vinyl reinforcement at the pintles to extend the life of the cover
The cover is also reinforced at the bow
You can add reflective tape in the upgrade menu found above. We offer this cover in four different fabric types, look over the fabrics in the drop down chart below.
Putting a tennis ball on the top pintle will help extend the life of your cover by distributing the load of your cover at that chafe point! (even if you don't do this we have reinforced this point on your cover with heavy duty truck vinyl so the pintle will not punch through it.
Because we take the time to make sure you are getting what you want and need. Our knowledgeable designers are available by phone or email and can work with you to incorporate any special requests. Our products are warranted against defects due to workmanship or material flaws for 1 year. All our products are made in the USA, on the central coast of California.