Our Sunfish® mooring cover fits snugly below the rub rail of the hull to seal out dirt and water.
This cover is installed with the mast up and the spars and sail down. This cover is held on by an elastic cord in the hem of the cover; there are also tie down points about every three feet around the cover. There is a cutout for the mast that has a tall tie-on collar; the mast cutout is connected to the side of the cover with a large #10 YKK zipper between the mast cutout and the starboard gunwale. The zipper is also covered with a flap of fabric to increase UV resistance. The spars and sail that protrude off the back of the boat are covered with an attached Velcro on flap that wraps around the spars, protecting your spars and sail from UV damage.
This sailboat cover is compatible with our Sunfish® hull cover if you want to completely enclose your boat.
You can add straps (click here for more information) and/or a bow cutout in the upgrade menu found above.
We offer this cover in three different fabric types, look over the fabrics in the drop down chart below.
This cover will work best and allow for the main halyard to remain completely run through the masthead and deck leads if it is 29 feet long or longer. Shorter main halyards will work but you may need to partially unreeve them to make it all work fine. The SLO Sail and Canvas Sunfish Line kit will be nicely compatible with this cover. CLICK HERE to be redirected to our specialty Sunfish Main Halyard Line Only - 30' length for use with Mast Up Flat Covers.
Sunfish® is the registered trademark of Laser Performance Sailboats. SLO Sail and Canvas is not an authorized dealer or distributor of Sunfish® Sailboats, parts or accessories, or a licensee of Laser Performance Sailboats. Laser Performance Sailboats neither approves nor authorizes products sold by SLO Sail and Canvas.
Received cover. It surpasses the quality I expected and it looks great! Thanks for the a great JOB to all. George on 13th Jan 2015
I received my new Sunfish cover last fall and used it on my very vintage Sunfish. When I opened the cover last month, the boat was completely dry and clean! Now that sailing season is here, I enjoy being able to keep the spars, sail and deck protected and no longer have to remember to replace the drain plug before launching. The cover is extremely well made and easy to use after each sail. Thank you! Jane S. Sunfish Mast Up Polyester Blue on 22nd Dec 2014
Why SLO Sail and Canvas?
Because we take the time to make sure you are getting what you want and need. Our knowledgeable designers are available by phone or email and can work with you to incorporate any special requests. Our products are warranted against defects due to workmanship or material flaws for 1 year. All our products are made in the USA, on the central coast of California.