The Mutineer sailboat mast up flat cover will completely enclose your Multineer deck, protecting it from the elements. Our Multineer cover fits snugly below the rub rail of the hull to seal out dirt and water. The cover installs securely with an elastic cord and tie down points. This cover is installed with the mast up and has four cutouts: one for the mast two for the shrouds and one for the forestay. All four cutouts have Velcro closures and a large #10 YKK zipper is used between the mast base cutout and the starboard shroud cutout for ease of use and durability. The zipper is also covered with a flap of fabric to increase UV resistance.
You can add straps and/or reflective tape in the upgrade menu found above.
We offer this cover in three different fabric types, look over the fabrics in the drop down chart below.
Depending on who built your boat we many need measurement to know where you shrouds and forestay.*
A From the center back edge of the Transom right above the gudgeons to the invisable line that connects the shrouds
B From center of the port side shroud chainplate to the center of the starboard side shroud chainplate
C From the center back edge of the Transom to the center for the forestay.
Please see diagram above for clarification or call (805) 479-6122. From what we know the mast position doesn't change.
Why SLO Sail and Canvas?
Because we take the time to make sure you are getting what you want and need. Our knowledgeable designers are available by phone or email and can work with you to incorporate any special requests. Our products are warranted against defects due to workmanship or material flaws for 1 year. All our products are made in the USA, on the central coast of California.