The Laser II sailboat Mast Up Cover will completely enclose your Laser II deck, protecting it from the elements while the mast is up.
Our Laser II cover fits snugly below the rub rail of the hull to seal out dirt and water. The cover installs securely with an elastic cord and webbing loop tie down points, about every three feet around the cover. This cover is installed with the mast up and has four cutouts: one for the mast, two for the shrouds, and one for the forestay. The two shroud cutouts have Velcro closures. The forestay cutout is what we call a blunt bow, this means that the bow of the cover is cut off just behind the forestay and there is a strap with a buckle that goes around the bow of the boat. This is done because the forestay is so close to the bow of the boat. For the mast cutout, a large #10 YKK zipper is used between the mast base cutout and the starboard shroud cutout for ease of use and durability. The zipper is also covered with a flap of fabric to increase UV resistance. There is a tall collar that ties securely around the mast.
This sailboat cover is compatible with our Laser II Bottom Cover if you want to completely enclose your boat.
You can add straps and/or reflective tape in the upgrade menu found above.
We offer this cover in three different fabric types, look over the fabrics in the drop down chart below.
Why SLO Sail and Canvas?
Because we take the time to make sure you are getting what you want and need. Our knowledgeable designers are available by phone or email and can work with you to incorporate any special requests. Our products are warranted against defects due to workmanship or material flaws for 1 year. All our products are made in the USA, on the central coast of California.